Fault Messages On The Display; Disposal; Spare Parts And Accessories - Hupfer KWP Manual De Instrucciones

Operating Instructions
Fault message
F1
EP

11 Disposal

EN

12 Spare parts and accessories

10.1.1 Fault messages on the display

Cause
Sensor fault
Data loss in the parameter memory
ATTENTION
Electrical components may only be removed by qualified
electricians.
ATTENTION
The cooling system may only be removed by refrigeration
specialists.
Proceed as follows for proper disposal:
►
Remove the electrical components.
►
Drain off refrigerant or coolant and dispose of it properly.
►
Remove the cooling system.
►
Take the components to a designated disposal centre.
Spare parts and accessories are available from Hupfer Service. When
ordering spare parts or requesting customer service, always state the
order number and the information on the rating plate. This helps avoid
queries from our customer service and speeds up the process.
Servicing may only be carried out by authorised specialist personnel.
Defective components should only be replaced with genuine spare
parts. Only then can safe and reliable operation be guaranteed.
Hot and cold plate
Remedy
The temperature sensor must be checked by a
specialist and replaced if necessary.
The integrated controller must be checked by a
specialist and replaced or repaired if necessary.
Page 23