Electrical Requirements; 230 Volt Conversion 30 Or 50 Amp; Conversion Instructions - HotSpring HOT SPOT Serie Manual Del Propietário

E R
LECTRICAL EQUIREMENTS
IMPORTANT: Fill the spa with water before turning on the power.
Your HOT SPRING spa has been carefully designed to give you
maximum safety against electrical shock. Connecting the spa to an
improperly wired circuit will negate many of the spa's safety features.
Improper wiring may also cause electrocution, risk of fire, and other
risks of injuries. Please read and follow the electrical installation
requirements and instructions for your specific spa model completely!
• The TX operates on 115 volts 15 amp 60Hz. This model can also be
converted to either 115 volt 30 amp or 230 volt 50 amp.
• The SX operate on 115 volts 20 amp 60 Hz. This models can also be
converted to either 115 volt 30 amp or 230 volt 50 amp.
When the TX & SX are connected to 115 volts 15 amp or 20 amp, the
heater will provide approximately 1000 watts of heat, only when the
pump is operating in LOW speed and the thermostat is calling for heat.
When these spas are connected to 115 volts 30 amp, the heater will
provide approximately 1000 watts of heat when the pump is operating
in LOW or HIGH speed and the thermostat is calling for heat. When
these spars are connected to 230 volts 50 amps, the heater will provide
approximately 4000 watts of heat when the pump is operating in LOW
or HIGH speed and the thermostat is calling for heat.

230 VOLT CONVERSION 30 OR 50 AMP

Conversion instructions

NOTE: An Authorized HOT SPRING Spa Technician must reconfigure spa
using the soft jumpers.
A licensed electrician must install the sub-panel (available from your HOT
SPRING Spa Dealer) to supply
power to the spa. The sub-panel must be placed in sight of the spa, at a
minimum distance of 5 feet (1.5 m) away.
230VAC, 30/50 Amp
2-Pole Circuit CIircuit
Breaker (Non GFCI)
#8 AWG White, Neutral
#10 AWG Green, Ground
#8 AWG Black, L1
50A
#8 AWG Red, L2
30/50A
Main
Service Electrical
Panel
Less Than 100 FT (30 m).

Electrical Requirements

English Spanish
WIRING ILLUSTRATION
OPTIONAL 30/50A, 230V SUBPANEL CONVERSION CONNECTION
230 VAC, 24/40A, 60HZ, CONVERTED MODELS
50A
30/50A
Sub-Panel with
GFCI Breaker
Page 24
French
Power Jumper Position
2 Position Power Jumper
must be removed on the
Terminal Block to operate
See Wiring
Illustration
below
N, Neutral, #8 AWG White
L2, Hot, #8 AWG Red
L1, Hot, #8 AWG Black
Ground, #10 AWG Green
More than 5 feet (1.5 m)
the Sub-Panel must be within
sight of the spa
Do Not Exceed 50 Feet (15 m)
230 VAC Wiring
(50A Converted)
230 VAC Spa Models
Control Box