Whalen SPUS-DZMF-LBM Manual De Instrucciones página 6

NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Securely screw the Cam Bolts (3) into the designated small holes on the Drawer Front Panels (H and I)
using a Phillips screwdriver. DO NOT overtighten the Cam Bolts.
NOTE: Screw-in cam bolts must be screwed down flush.
Release lever
S
3. Pick up the Ball Bearing Slides (S) and separate the slide runners for the following step. Extend the slide
runner all the way forward. Press the plastic release lever of the ball bearing slides up and pull the slide
runner complete out.
4. Using the pilot holes as a guide, attach the separated Slide Runners (S) to the Drawer Left and Right
Sides (K and L) respectively with three 14 mm Screws (7) per slide runner.
Drawer Assembling
H
UP
The open end points toward the edge with two
mounting holes running against
toward the same direction.
3
S
Mounting holes
7
S
7
7
K
6
I
7
7
7
S
L
Open end
x 2