Charging The Battery - Kamikaze Volpi Originale KV390 Manual Del Usuario

1 Capacity
2 Rated Voltage
3 Maximum Voltage
4 Operating Hours
5 Weight (battery)
1 Input Voltage
2 Output Voltage
3 Recharging Current
4 Protection Level
5 Charging Time
* 3600 cuts/per battery charge – Cutting Ø = 15 – 20 mm

10 Charging the Battery

Do not dispose battery under high temperature or vibration environment to avoid liquid
leakage from the battery.
isconnect the battery from tool before charging.
D
Always make sure the battery is dry and clean before charging.
• Make sure the battery is fully charged before first time using.
• The battery is not fully charged when you buy, you must charge 3-4 hours before using first time.
• Before recharging the battery, check the remaining charge on the display.
• Need to replace battery if battery running time is not enough. Users can only use the original
equipment manufactured by the customer center (OEM) battery pack.
• Keep safety rules and environment protection information in mind all the time.
10.1 Battery charging procedure.
• Recharge in a closed environment, at a temperature between + 10 ° C and 22 ° C.
• The three-way battery charger allows you to recharge all three supplied batteries at the same time.
• Make sure the characteristics of the charger and the battery are aligned before starting to charge.
• The red LED light on the charger indicates that the battery is charging, the green LED light indicates
that it is fully charged. The approximate charging time is 3 to 5 hours (charging time for 3 fully
discharged batteries at the same time), do not keep the batteries connected longer than necessary, as
they may damage them.
• The charger has three out puts, it can charge up to 3 batteries at the same time. The charging time is
78
3600 cuts *
Charger
100-240V AC ,50-60Hz
2.5 Ah
21.6V
25.2V
0.36kg
DC25.2V
1.4A
Ⅱ
3-5h