The washer stops when the program is running. The display window shows
fault code "F01","F03", "F13","F14", "F24",
or "Unb".
Displayed on Display Window
"F01"
"F03"
"F13"
"
"
"
"
"
"Unb"
The machine is not fed with water or insufficient water. Check:
Faucet is fully open and has enough water pressure.
Water inlet pipe is knotted or not.
Filtering net of water inlet pipe is blocked or not (refer to maintenance and
repair).
Water pipe is frozen or not.
Press "Start/Pause" key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale
service.).
The washer is not emptied. The washer stops the program being executed. Shut
down the machine and disconnect power supply. Check:
Drain pipe is knotted or not.
Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump)
Ensure that
Fault Description
Water inflow fault
Drainage fault
Door lock fault
verflow or too much foam.
"
Electronic module fault
Unbalance alarm
1
53
48
fault codes from
to "F98"