Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting
If your humidifier is not working properly, refer to the following:
Problem
• Power Switch is set to
On and Indicator Light
is Off
• Noticeable dripping
sound
• Little or no mist
is produced
• Water overflows
from Reservoir
• Condensation forms
around humidifier or
windows
• Float Paddle is
floating in the Base
• Water leaking from
Base or Reservoir
NOTE: FAILURE TO KEEP THIS UNIT CLEAN FROM MINERAL DEPOSITS NORMALLY
CONTAINED IN ANY WATER SUPPLY WILL AFFECT THE EFFICIENCY OF OPERATION OF
THIS UNIT. CUSTOMER FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE
WARRANTY.
10
Possible Cause
• Unit not plugged in
• No power at outlet
• Machine is stabilizing
• No water in Tank
• Unit is not level
• Mineral deposits on Nebulizer
• Water Tank was washed
with detergent
• Tank may be leaking
• Mist Intensity is set too high
for room size or
pre-existing humidity level
• Float Paddle not placed
correctly
• Unit may not be on level
surface
• Plunger is sticking or
damaged
• Tank is cracked
• Plunger may have foreign
material stuck under the Tank
Gasket
Solution
• Plug unit in
• Check circuits, fuses,
test outlet
• No action is required. The
noise level will decrease on
its own.
• Fill Water Tank
• Place on a level surface
• Follow Cleaning Instructions
on Pages 6-8
• Rinse thoroughly with
clean water
• Check the Tank for leaks and
replace if necessary
• Decrease mist output to
low setting, open door to
the room or turn the unit off
• Ensure Float Rod properly
placed on brackets over the
dotted line indicator
• Push and release Plunger to be
sure it is moving freely
• Inspect tank for damage;
contact Consumer Relations
• At sink, push and release
Plunger system so water
may flow
Tabla de contenido
