Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MANUAL DE INSTRUCCIONES
J
.P. SELECTA s.a.u.
Select Suck-back parameters
Turn on the power, enter the initial interface, Click Settings, enter the
setup menu; Click System Set, enter the system setup menu; Click
Suck- back, enter the suck-back set menu; Choose the suitable
control items (angel and speed); Click Enter, saved and exit; Click
CODIGO 80418 REV 0
Cancel, exit without saving.
10. Calibration
Calibration Guide
Pump accuracy calibration, in order to reach the high precision
dispensing, when the pump replace a new hose, external conditions
Pump accuracy calibration, in order to reach the high precision dispensing,
changed or other conditions causing flow rate deviation, the flow
when the pump replace a new hose, external conditions changed or other
rate can be corrected to meet users' requirements of flow accuracy.
conditions causing flow rate deviation, the flow rate can be corrected to meet
Turn on the power, enter the initial interface, Click Settings, enter
users' requirements of flow accuracy. Turn on the power, enter the initial
the setup menu, Click Calibration, enter the calibration guide menu:
interface, Click Settings, enter the setup menu, Click Calibration, enter the
calibration guide menu:
Use of dispensing type of crawling pump
Use of dispensing type of crawling pump
The interface shows the current using pump tube, conveying fluid
volume and advice calibration volume. If the suggested calibration
The interface shows the current using pump tube, conveying fluid volume
volume is big, you can reduce the value according to the filling
and advice calibration volume. If the suggested calibration volume is big,
condition; input the calibration value and then click Next, enter the
you can reduce the value according to the filling condition; input the calibra-
calibration menu, or click Exit Back to previous menu.
tion value and then click Next, enter the calibration menu, or click Exit Back
The interface shows the current using pump tube, conveying fluid
to previous menu.
volume and advice calibration volume. If the suggested calibration
volume is big, you can reduce the value according to the filling
condition; input the calibration value and then click Next, enter the
calibration menu, or click Exit Back to previous menu.
The pump will automatically stop after finishing setting, or click Cancel to
cancel the calibration, and return to the calibration interface.
After 3 times calibration and enter the measured values, click Next to save
11
the data, click Exit, to finish the calibration.
Mode Selection
The system default allocation mode
Data
Preserve the existing filling data; you can save at most nine filling data
11
It has Delete Save Use Exit Options
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.grupo-selecta.com
Calibration Wizard:
Pipe:14#, Flowrate:224.8ml/min
320ml
Amount of flowrate:
Interface analysis correction guide
(pls enter the actual
for the crawling pump
value you need)
Calibration Data:
Next
Interface analysis correction guide
321.3ml
Liquid volume 1:
for the crawling pump
321.3ml
Calibration Guide Interface
Liquid volume 2:
Calibration Data:
321.3ml
Liquid volume 3:
321.3ml
Liquid volume 1:
(Tested repeatedly input the results)
321.3ml
Liquid volume 2:
Back
Next
321.3ml
Liquid volume 3:
Actual filling volume interface
(Tested repeatedly input the results)
Back
Next
Actual filling volume interface
Running:
Time reamining:85. 41s
Running:
Cancel
Time reamining:85. 41s
Countdown interface
Cancel
Countdown interface
11/2021
Exit
Exit
Exit
Tel 34 937 700 877 Fax 34 937 702 362
Pag.: 21
10
Tabla de contenido
