Settings; External Control - Selecta PR-2004 Manual De Instrucciones

INSTRUCTION MANUAL
J
.P. SELECTA s.a.u.
CODE 80418 REV 0

11. Settings

11.1 3 Roller Pump Head
Micro flow tube
Tube
Hose section
Wall thickness
Inside diameter
Continuous
Pressure
Interval
The basic flow tube
Tube
Hose section
Wall thickness
Inside diameter
Continuous
Pressure
Interval
Industrial hose
Tube
Hose section
Wall thickness
Inside diameter
Continuous
Pressure
Interval
11.1.1 Head installation
Take two special screws to insert them into the open holes of the pump head
separately. Insert the pump pivot bracket into the groove of the drive shaft seal
and, at the same time, fit the two special screws into the connection holes of the
disc. Screw them separately.
Use the long screw at the bottom to attach multiple pump heads.
Note: The user must try to use the same power to tighten both screws.
11.1.2 Installing the tubes
Pull the lever 180° to the left and open the top plate.
Lift the cartridges from both sides separately and place the tube between the
rollers and the top plate.
Pull the lever 180º clockwise and push it into the correct position. The cartridge
presses the tube stably to prevent movement of the tube during the working
process.

11.1 External control

Drive external control interface (DB-15) introduction:
The 15-pin interface on the back of the machine is the controlling interface
to operate the machine through the external signals.
Firstly prepare a DB15 connector (with holes) and various colors signal wires,
then open the 15-pin interface, weld on the signal wires according to the
below sheet, and fix the wires together using the clip on the interface, you
may inject some glue to reinforce these wires; and at last install the shell
and screws.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.grupo-selecta.com
Use of dispensing type of crawling pump
Tubing technical parameters
Tel 34 937 700 877 Fax 34 937 702 362
11/2021 Page: 22
18