Connection To Drains; Technical Features; Possible Uses - Gastrodomus GAL4100TN Manual Del Usuario

Do not use solvents or harsh or abrasive cleaners. When cleaning, do not go near parts that could cut
yourself (evaporator, condenser, etc.) with your bare hands, and always use protective gloves.
4.3 ELECTRICAL CONNECTION (models with built-in condensing units) (fig. 4).
built-in condensing units) (fig. 4)
Check that the power supply meets the requirements indicated on the factory label and that it is equipped with a fault
protection or automatic circuit.
and that it is equipped with a fault protection or circuit breaker with an efficient ground connection.
automatic circuit breaker with an efficient ground connection. If there is no
electrical safety device, it should be introduced by a qualified person by means of
an omnipolar switch, as indicated in the safety standards, with a minimum contact distance of 3 m.
minimum contact distance of 3 mm. If the cabinet is to be
the cabinet is to be installed at some distance from the electrical source, ensure that the
connection complies with local standards. Cabinets supplied with
integral condensing units are provided with an appropriate plug equipped with a
neutral and ground: the power cord must be tightly tensioned (avoid windings and overlaps), must not be exposed to
the possibility of damage by third parties.
From third parties. It must not be in contact with liquids, water or heat sources.
heat sources, must be replaced by qualified personnel in case of damage.

4.4 CONNECTION TO DRAINS

Defrost water dispersion is automatic in all models with integrated condensing unit; remote condensing unit mode
can be provided for
built-in condenser; models with a remote condenser unit can be equipped with a heater for evaporation of defrost
water.
With a heater for defrost water evaporation.

5. TECHNICAL FEATURES

5.1 SAI dimensions (fig.2-fig.5)
The external and internal dimensions and capacities for the various configurations are listed in Fig. 5.
Configurations are shown in fig. 2 and 5.

5.2 POSSIBLE USES

Do not use the equipment to store medical materials. The equipment
operates under unfavorable conditions such as those recorded in class 4 of ISO standards
1992 (ambient temperature +30°C +1°C relative humidity 55%).
27