I.how To Use It; Ii.features; Iii.circuit Diagram - Gastrodomus WB-8LS Manual Del Usuario

I.How to use it

1. Place the boiler on a flat, smooth, dry and stable table, then pour the water (clean the inner tank when
using for the first time), the amount of water should not be less than the "MIN" water fill line, or over the
"FULL" water fill line.
2. Connect the power, and press the "ON" button, then turn on the thermostat knob with clockwise
rotation, set to 100C. If the water in the surrounding area is very hot, the water temperature should not be
lower than "MIN" or higher than "FULL".
3. Connect the power and press the "ON" button, adjust the temperature with the thermostat knob with a
clockwise rotation, adjust to 100C. The red light will turn on, then the boiler will start to heat up. When it
reaches the temperature of the setting, the boiler will stop heating and return to keep warm, then the
yellow light will light up, the boiled water is drinkable.
4. If the water continues to boil, please reverse the direction of the thermostat knob with anticlockwise
rotation until it stops heating.
5. When the water heater is in KEEP WARM mode, you can switch the thermostat to a high temperature as
the red indicator light illuminates, it will start heating. If the water is boiling, turn off the thermostat and
stop. Please note that do not drink the boiling water repeatedly.
Reminder: Please follow the given instruction.

II.Features:

Model
WB-8LS
WB-10LS
WB-15LS
WB-18LS
WB-22LS
WB-25LS

III.Circuit Diagram

Power/Volt
1500
1500
2500
2500
2500
2500
Capacity/L Dimension/mm
8L 230x230x472mm
10L 230x230x510mm
15L 290x290x485mm
18L 290x290x515mm
22L 290x290x580mm
25L 290x290x643mm8L
11