Water Connection; Recycling; Instructions For Use And Maintenance - Fagor SB-G910 Instrucciones De Instalación, Uso Y Mantenimiento

4. MODELS SB-G910 AND SB-G915: For the different gas configurations of the tilting Bratt
pan, the output pressure of the gas valve (Preg) must be adjusted according to the different
categories of gas as indicated in the table in section (3).
N.G. P = 15 mbar
reg
AT, CH, DE, PL
L.P.G.
OTHER COUNTRIES Cancelled
Cancelled Turn the regulator (Rv) clockwise until it stops.
P
reg
Adjusted
5. After adapting the appliance to another type of gas or to another pressure, other than that for
which it had been previously set, the old instructions should be replaced with the instructions
for the new settings, to enable unambiguous identification of the state of the appliance after
modification.
4.7

Water connection

The general installation must have a stop-cock. The water inlets are defined in the "General
dimensions and connections" section with the letter A.
The recommended water pressure is between 2 and 4 bars and the maximum temperature is 60°C
The water inlets on the appliances are ¾".
The appliance is installed in accordance with the EN 1717 standard and national water regulations.
4.8

Recycling

The product packaging consists of:
• A wooden pallet.
•
Cardboard edge protectors.
•
A polypropylene band.
•
A plastic bag.
All the packaging used around the machine can be recycled; The correct disposal of these products
will help to protect the environment. For further information regarding the recycling of these products,
please refer to the relevant office of the local government. Dispose of these materials in accordance
with current legislation.

5. INSTRUCTIONS FOR USE AND MAINTENANCE

BEFORE STARTING THE APPLIANCE, PLEASE READ THE INSTRUCTIONS
CONTAINED IN THIS MANUAL CAREFULLY.
P =28 mbar
reg
Turn the control (Rv) to the dynamic pressure shown in Table 3.
34