Concept VR3520 Manual Del Usuario página 82

EN
5. Connecting a mobile app (you can skip this step)
Read the instructions for connecting Wi-Fi and connect
the mobile app.
6. Start of cleaning
After switching on the robot, briefly press the button
on the robot or start cleaning using the mobile app
(you can pause the appliance by pressing any button
during use).
Note:
• The sweeping robot cannot be used to remove fluids.
• If the battery charge level is less than 15 %, the
appliance cannot operate. In this case, recharge it.
• If the battery charge level is less than 15 %, the
appliance automatically returns to the docking
station.
• Before use, remove various wires (including the
docking station power cord) from the floor to prevent
outages and damage to objects or wires when the
appliance catches these wires.
7. Installing the wiping module
a) Installing the wiping cloth: Stick the wiping cloth
straight to the bottom of the wiping module.
Wiping module
Note: Clean the wiping cloth after use to keep it in good
condition.
b) Fill the 2-in-1 container with water: Open the cover
and fill the water tank with water.
2-in-1 container
c) Install the module:
Press and hold the button in the centre of the
container and slide it horizontally along the back
of the robot. The 2-in-1 container is installed in
place when you hear a "click" sound and a voice
announcement from the appliance. After installing
82
the 2-in-1 container, insert the wiping module. Once
you hear a "click" sound, the module is correctly
inserted.
8. Removing the wiping module
Once the robot has completed its work, press the
latches on both sides, pull backwards and remove
the wiping module, empty the water from the 2-in-1
container and clean the cloth (do not move or flip the
robot during cleaning).
9. Instructions for using the wiping module
• Do not use the wiping module unless supervised.
• For safety, make sure the wiping module is removed
when charging or when not in use.
• Do not attempt to wipe the carpet.
• For a better wiping effect, the wiping module should
be used after sweeping or vacuuming the floor three
times.
• To refill water or clean the cloth while the appliance
is operating, pause it, remove and reinsert the wiping
module as described in steps 8 and 9. Do not move
or flip the appliance to avoid positioning errors and
map loss.
• The wiping function of the appliance is designed for
wiping and aids deep cleaning. However, it cannot
effectively remove stubborn dirt and thus replace
human power.
• We recommend soaking the wiping cloth before
mopping for better cleaning.
• If the robot has a wiping module installed, the dirt
from the 2-in-1 container will not be sucked out.
USE
ON/OFF
Press and hold the button
light comes on and the appliance starts.
Press and hold the button
appliance is in standby mode, the indicator light flashes
red and the appliance switches off.
NOTE: The appliance cannot be switched off while it is
being charged.
CLEANING/PAUSE
After starting the appliance, briefly press the button
the appliance or start the appliance using the mobile app
(press any button to pause the appliance).
Note:
• The robotic vacuum cleaner cannot be used to
remove fluids.
• If the battery charge level is less than 15 %, the
appliance cannot operate. In this case, recharge it.
• If the battery charge level is less than 15 %, the
for 3 seconds, the indicator
for 3 seconds while the
on
VR3520