Controls
A
A. Lamps knob
B. Blower knob
Operating the lamps
1 Turn the light switch to the "ON" position to turn the range hood
lights On.
2 Turn the light switch to the "OFF" position to turn the range
hood lights Off.
Maintenance
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads. Do not use chlorine base cleaners. Rub
in direction of the grain line to avoid scratching the surface.
Always wipe dry to avoid water marks.
• Stainless Steel Cleaner and Polish.
• Mild liquid detergent and water.
• Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal filters and drip trays:
1 Use 2 hands to remove filters.
2 Grasp filter handles, pull toward the front of range hood and
pull down on the rear handle to remove. Repeat for each filter.
A
A. Grease filter
3 Remove grease drip tray.
A
4 Place the drip tray bracket using the screws included.
C
B
A
B
A. Drip tray
A. Drip tray
B. Drip tray bracket
C. Drip tray bracket screws (2)
Operating the blower
1 Turn the blower switch at "1" to turn the range hood on.
2 Turn the blower switch to the desired speed position.
3 Turn the blower switch to the "MAX" position to turn the range
hood on High.
4 Turn the blower switch to the "OFF" position to turn the range
hood blower Off.
Auto On blower
The range hood is equipped with a sensor to automatically turn
on the blower when excessive heat is detected in the control area.
When the blower switch is in the "Off" position, this sensor will
turn the blower to high speed when necessary. When the heat
decreases, the blower will turn off. When the blower switch is in
the On position, the heat sensor is not active and the range hood
functions normally.
5 Wash metal filters and grease trays as needed in dishwasher
or hot detergent solution to clean.
6 Replace grease drip tray.
7 Reinstall filters, grasp filter handles and place front edge of
filter into the hood.
8 Push up on the back handle and set rear of filter into the drip
tray to secure. Repeat for each filter.
A
Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool.
To avoid damage or decreasing the life of the new lamp, do
not touch lamp with bare fingers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1 Disconnect power.
2 Push up on the lens and turn it counterclockwise.
3 Remove the lamp and replace it with a 120-volt, 7.5 W watt
maximum halogen lamp with a GU10 base. Turn it clockwise to
lock it into place.
4 Repeat steps 2-3 for the other lamps if needed.
5 Reconnect power.
A. Grease filter
13