Hoshizaki FM-1000ASFE3 Manual De Instrucciones página 3

ENGLISH
Note: A plumbing permit and services of a licensed
plumber may be required in some areas.
* Water supply pressure should be minimum 0.5
bar and maximum 8 bar. If the pressure exceeds
8 bar, use a proper pressure reducing valve. Do
NOT throttle back the supply tap.
* The icemaker drain is gravity flow, so ensure
drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
II. OPERATING INSTRUCTIONS
WARNING
. This icemaker is designed to produce
edible ice. To keep the icemaker hygienic:
* Wa s h y o u r h a n d s b e f o r e r e m o v i n g
ice. Use the Plastic Scoop provided
(accessory).
* The Storage Bin is for ice use only. Do
not store anything else in the Bin.
* Clean the Storage Bin before use (see "III.
. CLEANING").
* Keep the Scoop clean. Clean it by using
a neutral cleaner and rinse thoroughly.
* Close the Door after removing ice to
prevent entrance of dirt, dust or insects
into the Storage Bin.
2. T h e u s e o f a n y e l e c t r i c a l e q u i p m e n t
i n v o l v e s t h e o b s e r v a n c e o f s o m e
fundamental rules. In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in
doubt, disconnect the icemaker.
* Do not pull the power cord in order to
disconnect the icemaker from the feed
network.
* T h i s a p p l i a n c e i s n o t s u i t a b l e f o r
unsupervised use by young children or
aged or infirm persons.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the Compressor.
1. OPERATION
The installer will normally commission the icemaker
All manuals and user guides at all-guides.com
to start the automatic icemaking process. To
ensure continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
Note: The flake size is adjustable to standard and
2. PREPARING THE ICEMAKER FOR LONG
STORAGE
) Push the Stop Button on the Operation Panel.
The Display will blink in the "STOP" mode for 5
minutes during the drain control operation and
will start to illumintate constantly at the end of
drain control.
2) Close the water supply tap.
3) Remove the Inlet Hose from the water tap, and
drain the Hose.
4) Disconnect the power supply.
5) Remove all ice from the Storage Bin, and clean
the Bin.
III. MAINTENANCE
1. CLEANING
. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
2. Ask a trained service person to check and
3. This appliance must not be cleaned by use
[1] Machine and Bin Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
2
large sizes. The adjustment is made by
removing one of the two identical cutters
combined together. The unit is shipped
from the factory in the standard size. If
adjustment is desired, please contact an
authorized Hoshizaki service company.
WARNING
maintenance operations, disconnect
the icemaker from the electrical supply
network.
clean the Condenser at least once a year.
of a water jet.