KALLISTA P23052-CR Instrucciones De Instalación página 4

INSTALLATION INSTRUCTIONS
‰ Ensure the valve stem adapter is lightly placed over the spline adapter.
‰ Place the handle assembly over the valve stem adapter.
‰ Turn the handle clockwise until the stop is contacted. The valve will be in the full cold position. The handle
should be between 9 and 10 o'clock positions. To adjust the position of the handle, refer to the alignment
instructions below.
‰ Rotate the handle assembly counterclockwise, through the detent, then to the high temperature limit stop.
‰ Verify that the handle assembly is between the 3 and 4 o'clock position.
‰ Rotate back to the 6 o'clock position.
‰ Remove the handle assembly and set aside.
Handle Alignment Adjustments
NOTE: The spline adapter allows fine adjustment of the handle alignment.
‰ Remove the handle assembly and the valve stem adapter.
‰ Reposition the spline adapter.
‰ Reinstall the handle assembly and the valve stem adapter.
‰ Check the alignment.
‰ Repeat until the handle alignment is satisfactory.
1491208-2-A
4 of 16
2. ADJUST THE HANDLE ASSEMBLY
Thermostatic Valve Trim
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.