Maintenance/Cleaning; Cleaning And Servicing The Blade Knife Bar; Storage; Wall Bracket - Parkside PHS 450 A1 Traducción Del Manual De Instrucciones Original

GB IE
2. Cut the top edge, according to taste,
in a flat shape, roof shape or rounded
shape.
3. Trim young plants to the required
shape. The main growth should re-
main undamaged until the hedge has
reached the planned height. All other
shoots are lopped off to half size.
Care of Free-Growing Hedges:
Free-growing hedges are not shaped when
cut, although they must be regularly main-
tained so the hedge does not become too
high.

Maintenance/Cleaning

Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
Pull out the power plug before car-
rying out any work on the equip-
ment. There is a risk of electrocution
or of injury from moving parts.
Wear gloves while handling the
blades. Risk of cuts.
Do not use any cleaning agents or
solvents. These could cause irrepa-
rable damage to the equipment.
Chemical substances can attack the
plastic parts of the equipment.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
• Before each use, check the hedge trim-
26
mer for obvious defects such as loose,
worn or damaged parts. Check the
secure seating of the bolts in the cutter
bar ( 2).
• Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
• Check coverings and safety devices
( 1+3) for damage and correct seat-
ing. To replace the impact protection
( 1) or in case of damage to the
hand guard (
our service centre.
• Keep the ventilation slots (
motor housing of the device clean. Use
a damp cloth or a brush to do this. Do
not wash down the equipment with wa-
ter, or submerge it in water.
Cleaning and servicing the
blade knife bar
Clean the cutter bar (2) carefully after each
use. After using the equipment, it is impera-
tive to:
- Clean the blade (with an
oily cloth);
- Oil the blade shaft with
an oil can or spray.

Storage

• Clean the equipment before putting it
away.
• Keep the trimmer in the blade protec-
tion ( 10) supplied, in a dry place
and out of reach of children.

Wall bracket

You can hang the motor part on the wall
with the keyhole bore (11) on the bottom
of the device.
3), send the device to
5) and