Tabla de contenido
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
General working instructions
While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
•
Check the grass and bush trimmer blades
for obvious defects such as loose, worn
or damaged parts. Check that the screws
are seated i rmly in the blade block.
•
Remove the power supply unit (
before working with the equipment. Do
not use extension cables. The power
supply unit is to be used only in en-
closed spaces.
•
Only use sharp blades to achieve a
good cutting performance and preserve
the battery.
•
Do not work the unit so hard that it
comes to a standstill.
•
Pay attention to the instructions on unit
maintenance and cleaning.
Use as a grass trimmer
•
Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° in both directions.
The cutter head (1) features 3 positions:
+90°, 0°, -90°.
1. Operate the unlocking mechanism (4)
and turn the cutter head (1) into the de-
sired position.
2. Release the unlocking mechanism (4) so
that the cutter head (1) locks into place.
Use as a hedge trimmer
•
Move the unit forward evenly.
•
The double-sided cutting heads enable
cutting in both directions or by swing-
ing the unit from side to side.
Cleaning/Maintenance
Leave any work not covered
in this manual to our Service
Centre. Only use original
parts. There is a risk of injury!
14)
Ensure that the safety key (
removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
•
Check the covers and guards for dam-
age and correct position. If necessary,
replace.
•
Never operate the machine with defec-
tive guards or covers or without protec-
tion or with damaged or worn cables.
•
Keep the ventilation slits, motor housing
and handles on the equipment clean. To
do this, use a damp cloth or brush.
•
Always keep the blade clean.
After using the equipment, it is impera-
tive to:
- Clean the blade
(with an oily cloth);
GB
MT
7) is
10/12). There is a risk
65
Capítulos
Tabla de contenido
