Information On Safety; Intended Use - afriso AFA 11 Manual De Instrucciones

EN
2.2

Intended use

This product may only be used to signal accumulations of liquids during mon-
itoring of:
• Collection facilities under storage tanks, burners or motors
• Containers (tanks) with collection facilities which are not visible
• Collection facilities below devices consuming oil
• Manholes, pipe and cable ducts
• Pump and control stations where oil can accumulate due to leaks or back-
flow
The product is suitable for liquids to which the material of the photoelectric
probe is resistant:
• Diesel fuel (DIN EN 590) and low-viscosity oils with flash points of > 55 °C
at atmospheric pressure and at temperatures of -10 °C to 60 °C in dry
rooms
• Fuel oil EL
• Unused and used motor oils (for example, SAE 15W-40), gearbox oils
and hydraulic oils, transformer oils and vegetable oils, hydrogenated veg-
etable oils (HVO)
• Paraffinic fuels (GTL) as per DIN EN 15940
• AdBlue® (urea solution 32.5 %) as per DIN 70070/ISO 22241
• Water, grey water
The owner or operator must ensure that the components and the overall sys-
tem meet all directives and regulations applicable at the installation site, for
example, the directives pertaining to water and waterways.
Leak detection system class III as per DIN EN 13160-1 and DIN EN 13160-4
as liquid sensor system in leak or interstitial spaces, as safety device as per
worksheet DWA-A 791 or leak detection system as per worksheet
DWA-A 779.
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
4

Information on safety

AFA 11