Urrea TB812 Manual De Usuario página 10

• Before switching on the machine, make sure
the chuck has been mounted correctly, the drill
has been mounted into the chuck firmly and
the safety guard has been shut.
• In operation, use the recommended speed
for the drilling accessories and the material.
• Switch off the power, remove the drill and
clean the table before leaving the machine.
• Lock the on/off switch when leaving the ma-
chine.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
Your drill press has been designad for drilling
hales in wood, metal and plastics.
Fig.1
1. ON/OFF SWITCH.
2. PULLEY SYSTEM COVER.
3. SCREW.
4. SLIDE ROD SCREW.
5. SLIDE ROD.
6. PILLAR LOCKING HANDLE.
7. HANDLE.
8. TABLE LOCKING NUT.
9. CHUCK.
10. SAFETY GUARD.
11. LIFT HANDLE.
12. DRILL LIFT
13. DEPTH ADJUSTMENT.
10
ASSEMBLY INSTRUCTIONS
ASSEMBLING THE MACHINE (Figs.2-6)
Install the machine on a level and salid surface.
• Mount the pillar (16) to the foot (14) using
the bolts (15).
• lnsert the toothed rack (19) into the shaft
(18).
• Hold the rack with the teeth against the right
innerside of the shaft and slide the table (17)
over the pillar.
• Slide the spherical ring (20) over the pillar
with the wider opening facing downward to
make sure that the top end of the toothed rack
is locked. Tighten the Allen screw (21).
• Place the handle (7) onto the spindle (22) and
tighten the screw (23).
Fig.2
• Place the head (24) on top of the pillar. Firmly
tighten the Allen screws (25) to keep the head
in place.
Fig.4
• lnsert the drill shaft (26) witll the conical end
into the shaft (27). Turn the drill shaft until the
conical end engages.
Fig.3
Fig.5
Fig.6