Teac AG-H500 Manual Del Usuario página 13

COUNTRY country music
NATION-M national music
music from the so-called
OLDIES
golden of popular music
folk music
FOLK-M
documentaries
DOCUMENT
TEST
this is a program notifying an
ALARM
emergency or a natural
disaster.
(4) RT mode:
... When you select RT with the RDS mode
button, "RT" will blink for about 4
seconds.
... After 4 seconds, the data of received RT
will be displayed.
... If there is no RT data among received
broadcastings, RDS mode will be
automatically switched to PS mode.
(5) TA mode (TP Search Function):
... When you select TA with the RDS mode
button, "TA" will blink for about 4
seconds.
... After 4 seconds, TP received broad-
casting will be searched with FM
frequency increasing in 50 kHz steps.
... If TP received broadcasting is searched,
the increase in frequency will stop and it
is asked whether TA will be received or
not.
... When TA is received, the input selector
of the amplifier/receiver will be auto-
matically switched to the tuner.
... When TA has finished, the input selector
of the amplifier/receiver will auto-
matically return to the previous position.
... If TP and TA turn off while you are
receiving TA, the tuner will search TA
broadcasting again with FM frequency
increasing in 50 kHz steps.
How to Search For Your Desired
Program Using PTY Search
1
Select the tuner function.
2
Press the band button to select FM.
3
Press the RDS mode button on the
remote control for longer than 1.5
seconds.
Then "PTY SEEK" will be shown in the
display.
4
Select the desired PTY mode by using
the tuning/preset (or the preset call) up
( ) or down ( ) button.
... Select your desired one from among 31
kinds of PTY programs. (The program
will blink.)
5
Press the band button.
The program indicator is changed to
light steadily.
6
Press the tuning/preset (or the preset
call) up ( ) or down (
(Searching will start.)
... When the PTY mode that you have
selected is searched, searching will
stop and the PTY mode will be displayed.
... When you press the tuning/preset (or
the preset call) up ( ) or down (
button after your desired program is
searched, you can continue to search
for the same program type by increasing
or decreasing the frequency from the
current one.
... If the same program type is not found
during PTY search, it will stop at the
beginning frequency.
... If you want to cancel PTY search while
searching, press the RDS mode button.
Searching will stop and search mode
will be released automatically.
– 13 –
Back-up memory function
BACK-UP memory
This is the function which preserves the
preset memory and most-recent memory
functions. In the event of a power failure, or
if the power cord of this unit is
disconnected from the electric outlet, the
back-up memory will preserve the preset
memory and
functions for as long as approximately 3
days.
To Prevent Erasing the Memory
If the power supply is interrupted for 3 days
or longer, the memory settings will be
erased.
WHEN TO USE RESET SWITCH
1. When this system is subjected to an
electrical shock.
2. When the power is irregular.
) button.
In these cases, try the following (in
power standby mode):
)
– Rear panel –
Press the RESET switch lightly once
or twice with a pencil or a ballpoint
pen.
Note: When the RESET switch is pressed,
all the memory will be canceled.
most-recent memory
RESET SWITCH