Operating The Tuner; Sleep Timer Operation; Radio Reception; Manual Tuning - Teac AG-H500 Manual Del Usuario

Operating the Tuner

Sleep Timer Operation

This function allows you to preprogram the
receiver to switch its own power off
automatically.
You can then enjoy the audio system for a
specified amount of time without having to
worry about turning the unit off later.
Press the sleep button on the remote
control unit.
Each press of the sleep button changes the
time indication by 10 minutes.
∑sleep–90∑ sleep–80∑ ... ∑ sleep–10
(released condition) ß
To let the remaining time (until power off)
appear on the display while the sleep timer
is engaged, press the sleep button once.

Radio Reception

Auto Tuning
1
1
Select the tuner function.
2
Select the AM or FM by pressing the
band selector button.
3
Press the tuning mode button to change
to tuning mode.
(The PRESET CH. indicator disappears
from the display).
... This button is used to select tuning or
preset scan mode.
4
Press the tuning/preset up (
down ( ) button (within 0.5 to 2
seconds).
The next station broadcasting at a
frequency higher or lower than that of
the current station is automatically
detected and tuned in.
... By pressing and holding the tuning/
preset up ( ) or down (
longer than 2 seconds, it will continue to
control (three times faster than normal
speed).
– 10 –

Manual Tuning

Manual Tuning is generally used to tune to
stations broadcasting a signal that is too
weak to be received by Auto Tuning.
2 4 3
1
1
Select the tuner function.
2
Select the AM or FM by pressing the
band selector button.
3
Press the tuning mode button to change
to tuning mode.
(The PRESET CH. indicator disappears
from the display).
4
When the tuning /preset up (
) or
down
momentarily (0.5 second or less), the
frequency changes by a fixed step (see
STEPS below).
STEPS
Models for General Export/Europe
) button for
FM: 50-kHz steps
AM: 9-kHz steps
2 4 3
) or
( ) button is pressed