Initial Use - Herschel HAWAII 2000 Instrucciones De Instalación Y Funcionamiento

HANDLING WHILE INSTALLING:
Take care while installing to avoid touching the grill on the front of the heater. Be sure to wipe away any
finger marks from the heater before the heater is first switched on, since the oils in fingerprints can burn
and cause rapid discolouration of certain parts.
CAUTION:
• Ensure mains power is OFF and the unit is cool before commencing installation.
• The supplied mains cable must not contact the top surface of the heater during operation.
• Heater must not be located immediately above or below a socket outlet. Electrical connections must
be made outside of the footprint of the unit to avoid heat build-up in the connection.
• Joists, beams and rafters shall not be cut or notched to install the appliance.
• Overhead heater attachments must be capable of supporting 4x the weight of the unit (i.e. 14
kilograms or 31 lbs)
This heater is not intended for recessed installation.
•
The identification mark and model reference should be visible after installation.
•
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
•
must be protected, for example, by sleeving having an appropriate temperature rating.
• Ensure that wires are properly secured and cannot be pulled by small children.

INITIAL USE:

The power switch on the back (top side) of the HAWAII has 3 positions:
• Position O (Off)
Position I (Remote bypass)
•
Position II (Remote control).
•
CAUTION:
Bypass) during unpacking and installation. To avoid any possibility of burns, ensure the power
switch is in the OFF position (marked O on the switch) before switching on mains power.
Position I. To bypass the remote control, turn the switch on the heater to position I. When the switch is in
this position the heater will turn on or off depending on whether it has power to it. The remote control unit
will not control the heater when the switch is in position I. Use this where you wish to hard wire the heater
to a switching device such as a push button timer or thermostat.
Position II. To use the heater with the remote control, ensure the switch of the heater is switched to
position II.
Insert 2 x AAA Alkaline batteries into the remote control.
The remote control operates the heater remotely on or off only. There is no adjustable heat level.
However, all Herschel HAWAII remote controls share the same frequency, so it is possible to control
several heaters with just one remote.
There may be odour or vapour from the heater on initial use or if it has not been used for an extended
period. This is normal.
The power switch may become unintentionally switched to position I (Remote
ENGLISH