METRICA H4 Manual De Instrucciones página 10

POWER SUPPLY
The device works with:
- Set of 4 rechargeable NiMH C-type batteries, which is
attached to the underside of the unit.
Charger included.
FUNCTIONS
Horizontal planes: Place the device in the self-leveling range (±
5°), on a plane or on a tripod or a wall mount (not in scope of
delivery).
- Press the button (A) briefly to switch the device on
- The device is set in automatic mode
The beam will blink until the unit is in the self-leveling range.
Then, the beam rotates at 600 revolutions / minute. If the unit
is outside of the self-leveling range (± 5 °), the laser beam and
the LED of botton (A) are flashing. Put the device back into the
self-leveling range (± 5 °).
SPEED FUNCTION
To change the speed, press the button (E) of the remote control
- 1 time: the beam is fixed at 0 r / min
- 2 times: the beam rotates at 60 rev / min
- 3 times: the beam rotates at 120 rev / min
- 4 times: the beam rotates at 300 rev / min
- 5 times: the beam rotates at 600 rev / min
10
- for progressive moves of the laser point at 0 rpm, press the
buttons F or G subsequenty.
SCANNER FUNCTIONS
To access the scanner function press the button (H).
If pressed one more time, the projected beam will have a width
of 10 °, 45 °, 90 ° and 180 °.
To move the laser beam progressively, press the buttons F or G.
TILT-FUNCTION TO SIGNAL UNFORESEEN ACCIDENTAL
MOVEMENT OF THE UNIT
If the unit in the self-leveling mode, press the button (B) to
activate the TILT function. The LED (B) blinks slowly, after 30
seconds fast, and then stays on.
- If the unit is accidentally moved, the laser beam stops and
flashes.
- Switch the instrument completely off and on again by pushing
the button (A). The TILT function is disabled.
SLOPE FUNCTION (INCLINATION)
Put the device in a horizontal position to project a horizontal plane.
- Press the button (C)
- The LED (C) lights. The device is now in the manual mode.
Inclinations along the X-axis: Align the X1 axis in the desired
direction of inclination.