Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation material
The following installation accessories are supplied with unit. Use them as required.
name and shape
Wall hanging bracket
Screws 4xL10
Screws anchors and screws 4xL25
Washers Ø 12
Screws 3xL14
Screws 5xL25
Cordless remote control mounting bracket
The following field-supplied items are required to complete the installation.
name
Connection pipe
- Power supply cable
- Electrical connecting cable between indoor and
outdoor unit
Wall sleeve,Wall cap, Finishing tape (PVC film), Fastening tape, Pipe insulation, Drain hose (I.D. 16-17 mm), Sealer
putty.
Accessories
Description
Photocatalytic filter + Electrostatic filter
Photocatalytic filter + Electrostatic filter + Carbon filter
Installation
• (See fig. 5). The piping can be connected in the four
ways indicated by e, f, g and h. When the piping
is connected to points e, f or h, remove the knock-
out either at the side or at the bottom of the unit.
Installing the wall hanging bracket
• Install the wall hanging bracket so that it is level. Use a
plumb line i if necessary (See fig. 6).
• Be sure to leave the clearance spaces.
• If the wall hanging bracket is not level, water may drip
onto the floor.
• Install the wall hanging bracket with a fixing that is
strong enough to withstand the weight of the unit.
• Before installing the wall hanging bracket, remove it
from the unit by pushing at the indicated parts at the
bottom of the body (Remove screw j).
All manuals and user guides at all-guides.com
Q.ty
Use
1
For indoor unit installation
2
For fixing unit and hanging bracket
5+5+5 For wall hanging bracket installation (050, 070)
1
For cordless remote control mounting bracket installation
14
For wall hanging bracket installation (100)
1
For cordless remote control installation
050
070, 100
Specification
Ø (1/2") 12,70 mm (Gas) / Ø (1/4") 6,35 mm (Liquid)
Ø (5/8") 15,87 mm (Gas) / Ø (3/8") 9,52 mm (Liquid)
H07 RN-F (60245IEC66), cable with synthetic rubber
insulation and polychloroprene sheath
Part number
050, 070
42PHW9103
42PHW9104
ImPORTAnT nOTE:
This unit has no refrigerant expansion device.
• Fasten the wall hanging bracket to the wall with 4 or
more screw anchors through the holes near the outer
edge of the bracket.
• Install the wall hanging bracket so that there is no gap
between the bracket and the wall.
• Check that the wall hanging bracket does not move.
This can cause noise during operation.
• If the unit is removed from the wall hanging bracket
after installing it onto the wall, remove it by pushing up
the indicated MARKS (
42XPP
100
•
•
) at the bottom of the body.
42XPP
2
Tabla de contenido
