Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. INSTALLATION
1. Initial Set-up:
• Remove the product from the package.
• Verify if the product does not present problems due to transport and whether it is in operating conditions.
• Separate all the wrapped parts and compare each of the items with the figure and list of free parts (Chapter
Main Components).
• Before disposing the wrapping material (see Environmental Orientations and Recommendations Chapter),
make sure all the items have been found.
ATENÇÃO
Dealer so that the missing item can be supplied. After proper installation, you can use it normally.
2. Location:
• Install the bench drill in an area that is covered, illuminated, ventilated, free of dust, toxic gases, humidity
and any other kind of pollution. Places such as stockrooms, pantries, basements, garages, bathrooms and
chemically contaminated areas must be avoided. The room temperature must be adequate for the user and
the maximum recommended for the drill is 40ºC.
• Fix the bench drill on a flat, horizontal and leveled table with
3. Positioning:
• Keep a minimum clearance of 800mm from any obstacle to guarantee good ventilation during the operation
and access for the operator, and to facilitate cleaning and maintenance services.
4. Electrical connection:
• Consult a specialized technician to evaluate the general conditions of the electrical network and select the
proper electrical devices for supply.
• The local Norm for low voltage installations must be followed, according to the installation's location and
country.
• The electrical wires must be dimensioned according to the motor power, electrical network voltage and
distance from the energy source (orientations in Table 8.1) to the motor, connected to the voltage (V), as
indicated on the tag on the electric motor or power cord.
• Before connecting the equipment to the electrical supply, check if the compressor's voltage matches the
local voltage.
• Do not wet the electric components, since water may cause short-circuit and component burning or electri-
cal shock.
• For safety and warranty of the electric motor, the orientation on Figure 8.1/8.2 must be followed. The non-
-compliance might cause the motor to burn out and warranty loss.
•
Grounding instructions: this product must be grounded. In case of short circuit, grounding reduces the
risk of electric shock through a discharge path of the electric current. Therefore, connect the grounding wire
to the motor's terminal or, if there is no terminal, to the motor's housing.
All manuals and user guides at all-guides.com
Do not operate the drill bench if any items are missing. Contact a Schulz Authorized
bolts.
38
Tabla de contenido
