Compact Blender And Juice Extractor Troubleshooting - Cuisinart CBJ-450 Manual De Instrucciones

COMPACT BLENDER
TROUBLESHOOTING
Problem:
My blender is not
turning on
The blender stops running
The blade assembly is hard
to remove after blending
Unit appears to be leaking
Solution:
Be sure the blade assembly is on the
blending cup correctly and locked into place
Plug the blender into an independent and
electrical outlet and make sure the blender
is securely plugged in. If it still doesn't work,
try plugging into a different outlet and/or
check your home's circuit breaker.
The motor could have overheated.
The resettable fuse, which protects the motor
if overloaded, may have been tripped. When
this happens, reset the appliance by unplug-
ging it and letting it cool for a minimum of 15
minutes. Then, reduce the contents
of the blending cup and/or clear any jams.
Restart the unit as noted in the operating
directions.
The ingredients cause pressure, and with the
airtight seal, pressure builds up creating a
vacuum or a suction effect. This is normal.
Check rubber gasket and make sure it's flush
with the blender assembly. You can also
check the rubber gasket to see if is in place
or even damaged. The blade assembly should
be tight.
COMPACT JUICE EXTRACTOR
TROUBLESHOOTING
Problem:
Juice extractor does not turn on
The juice extractor stops running
Juice flow is slow
Difficulty getting herbs or leafy
greens down the feed tube
Unit is on but juice/pulp
not flowing
8
Solution:
Check to see if the locking clamps are
properly engaged.
(See Assembly Instructions, page 6.)
Turn to HIGH to start juicing.
The motor could have overheated.
The resettable fuse, which protects the motor
if overloaded, may have been tripped.
When this happens, reset the appliance by
unplugging it and letting it cool for a minimum
of 15 minutes. Then, reduce the contents or
clear any jams. Restart the unit as noted in
the operating directions.
Excess pulp in mesh filter basket can
slow juice rate. Stop the juice
extractor and clean filter basket.
Place herbs between other ingredients. When
using leafy greens, always place the leafy side
in first and do not over pack the feed tube.
Make sure the mesh filter basket/blade
is in place.