The First Wash Cycle; Technical Data - Hotpoint ARMXXF 1690 Instrucciones De Uso

Connecting the drain hose
!
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the washer-dr-
yer. If this is not the case, replace the socket or the plug.
!
The appliace must only be installed indoor in a frost free
and dry room, to prevent it from electronic damage due to
frost or condensation.
!
When the washer-dryer has been installed, the electricity
socket must be within easy reach.
!
Do not use extension cords or multiple sockets.
All manuals and user guides at all-guides.com
Connect the drain hose,
without bending it, to a drai-
nage duct or a wall drain
located at a height between
65 and 100 cm from the
floor;
alternatively, rest it on
the side of a washbasin
or bathtub, fastening the
duct supplied to the tap
(see figure). The free end
of the hose should not be
underwater.
!
The cable should not be bent or compressed.
!
The power supply cable must only be replaced by autho-
rised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the wash cycle 1.

Technical data

Model ARMXXF 1690
width 59,5 cm
Dimensions height 85 cm
depth 53,5 cm
from 1 to 7 kg for the wash programme;
Capacity from 1 to 4 kg for the drying pro-
gramme
Electrical please refer to the technical data plate
connections fixed to the machine
maximum pressure 1 MPa (10 bar)
Water connec-
minimum pressure 0.05 MPa (0.5 bar)
tion
drum capacity 52 litres
Spin speed up to 1600 rotations per minute
Wash: programme 6; temperature
60°C; run with a load of 7 kg.
Energy rated
Drying: the smaller load must be
programmes
dried by selecting the "
according to
level. The load must consist of 2 she-
regulation
ets, 1 pillowcase and 1 hand towel;
EN 50229
the remainder of the load must be dri-
ed by selecting the " " dryness level.
This appliance conforms to the
following EC Directives:
- 2004/108/EC (Electromagnetic
Compatibility)
- 2012/19/EU
- 2006/95/EC Low Voltage)
GB
" dryness
3