Cleaning And Maintenance - cecotec BOLERO 10700 Manual De Instrucciones

ENGLISH
compliance with Regulation (EU) 2019/2023.
4. The Wash & dry programme, with the Extra dry level, is able to clean cotton clothes
normally soiled declared as washable at 40ºC or 60ºC in the same cycle, and to dry them
so that they can be immediately stored in a cupboard. This programme is used to asses
compliance with Regulation (EU) 2019/2023.
- The most efficient programmes in terms of energy consumption are generally
those that are carried out at lower temperatures and longer duration. Loading the
washer-dryer up to the recommended capacity for the respective programmes will
contribute to saving energy and water.
- Noise and residual moisture content are influenced by the spin speed: the higher
the spin speed, the higher the noise and the lower the residual moisture content.
Note
If there is an interruption in the power supply while the unit is in operation, a memory
stores the previously selected program. The unit will resume the programme when
power supply is restored.

5. CLEANING AND MAINTENANCE

Warning
Before cleaning or maintaining, unplug the appliance and close the tap.
- Proper maintenance on the washing machine can extend its working life. The
surface can be cleaned with diluted non-abrasive neutral detergents when
necessary. If there is any water overflow, use a cloth to wipe it off immediately. Fig.
24.
- Do not use abrasive cleaners or scouring pads to clean the product.
Cleaning the drum
- The rusts left inside the drum by the metal articles shall be removed immediately
with chlorine-free detergents.
- Do not use steel wool.
Note
Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
- Wipe the glass and seal after each wash to remove lint and stains. If lint builds up
it can cause leaks.
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
82
- Remove any coins, buttons and other objects from the seal after each wash. Fig. 25.
Cleaning the inlet filter
Note
The inlet filter must be cleaned when there is little water.
Washing the filter in the tap
Fig. 26.
5. Close the tap.
6. Remove the water supply hose from the tap.
7. Clean the filter edge.
8. Reconnect the water supply hose.
Washing the filter in the washing machine
Fig. 27.
5. Screw off the inlet hose from the backside of the machine.
6. Pull out the filter with long nose pliers and reinstall it back after being washed.
7. Use the brush to clean the filter.
8. Reconnect the inlet hose.
Note
If the brush is not clean, pull out the filter and wash it separately. Then, reconnect it
and turn on the tap.
Cleaning the detergent dispenser
8. Press down the arrow on the softener cover inside the dispenser drawer.
9. Lift the clip up and take out the softener cover and wash all grooves with water.
10. Replace the softener cover and push the drawer into position.
11. Pull out the dispenser drawer by pressing the A. Fig. 28.
12. Clean the dispenser drawer under running water. Fig. 29.
13. Clean inside the recess with an old toothbrush. Fig 30.
14. Insert the dispenser drawer. Fig. 31.
Warning
Do not use alcohol, solvents or chemical products to clean the washing machine.
Cleaning the drain pump filter
Warning
Be careful with the hot water!
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
ENGLISH
83