cecotec BOLERO 10700 Manual De Instrucciones página 37

ENGLISH
- Loosen the clamp nut and four bolts.
- Tighten the clamp nut.
- Press slide bushing and insert inlet hose into connecting base.
- Connection finished.
- Connection between screw tap and inlet hose. Fig. 9.
- Tap with threads and inlet hose.
- Special tap for washing machine.
- Connect the other end of inlet hose to the inlet valve at the backside of product and
fasten the pipe tightly clockwise. Fig. 10.
Drain hose
Note
- Do not kink or protract the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
- There are two ways to place the end of the drain hose:
- In a drainpipe. It is recommended to use a vertical tube.
- In a sink's drainpipe, over the trap.
Fig. 11.
If the machine has drain hose support, it can also be installed on a sink or a tank, like
the following. Fig. 12.
Warning
When installing the drain hose, fix it properly with a rope. If the drain hose is too long,
do not force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operating it.
- Before washing the clothes for the first time, the product shall be operated in one
round of the whole procedures without the clothes inside.
Calibration
6. It is recommended to calibrate the device. To do that:
7. Empty the washing machine.
8. Plug it in.
9. Turn on the device and press Speed and Delay start at once for a maximum of 10
seconds. The display will show "t19".
10. Press the Start/Pause button to start or pause the washing cycle. The display will
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
72
show different numbers, when it shows a steady figure the washing machine is
calibrated, you can turn the device off.
QuickStart
Before washing
6. Plug the device into a power supply.
7. Open the tap.
8. Load the washing machine.
9. Close the door.
10. Add detergent.
Fig. 13.
Note
Detergent must be added in "case I" only after selecting pre-washing for machines
with this function.
Washing
5. Turn the device on.
6. Turn the knob to select the desired programme.
7. Select function or use the default one.
8. Press Start.
Fig. 14.
Note
If any of the default options is selected, step 3 can be skipped.
After washing
The appliance will beep, or the display will show "End".
Using the washing machine
Before each washing
- The washing machine should be operated within a temperature range of 0-40
°C. If used under 0°C, the inlet valve and draining system may be damaged. If the
machine is placed or operated in rooms at 0°C or below, it should be transferred to
normal room temperature to ensure the water supply hose and drain hose are not
frozen before use.
- Check the labels and the product instructions when using detergent before
washing. Use non-foaming or less-foaming detergent suitable for machine
washing.
- Check the label. Fig. 15.
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
ENGLISH
73