Troubleshooting - Echo DSRM-2100 Manual Del Operador

TROUBLE SHOOTING
TROUBLE SHOOTING
Problem
The machine No electrical contact
does not between the machine
start when and the battery.
you push
The battery is depleted. Charge the battery.
the trigger
switch.
The lock-out lever and
trigger switch are not
pushed at the same
time.
The machine The debris shield is
stops when not attached to the
you cut. machine.
Heavy cutting line is
used.
The grass winds around
the motor shaft or the
trimmer head.
The motor is overload-
ed.
The battery or machine
is too hot.
The battery is
disconnected from the
tool.
The battery is depleted. Charge the battery.
26
Possible Cause Solution
1. Remove battery.
2. Check contact and install the battery
again.
1. Push the lock-out lever and hold it.
2. Pull the trigger switch to start the
machine.
Remove the battery and attach the
debris shield to the machine.
Use only with the nylon cutting line of
0.095" diameter line or smaller.
1. Stop the machine.
2. Remove the battery.
3. Remove the grass from the motor
shaft and trimmer head.
1. Remove the trimmer head from the
grass.
2. The motor will recover to work as
soon as the load is removed.
3. When you cut, move the trimmer
head in and out of the grass to be cut
and remove no more than 8" in pass.
1. Cool the battery until its function
returns to normal.
2. Cool the machine for approximately
10 minutes.
Install the battery again.
© 08/2021 ECHO Incorporated
DSRM-2100
99922205723