Tabla de contenido
Replace the nozzle
DANGER
Risk of injury! Switch the appliance off prior
to replacing nozzle and activate hand spray
gun until device is pressureless.
Secure the trigger gun. To do so, push
the safety catch towards the front.
Replacing the nozzle.
Cleaning
Set pressure/temperature and deter-
gent concentration according to the sur-
face to be cleaned.
Triple nozzle
Close the hand spray gun.
Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure flat spray (25°)
for large dirt areas
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray (CHEM)
for operating using detergents
or cleaning at low pressure.
Select round or flat spray using touch-less
switching:
Close the hand spray gun.
Turn the spray-pipe that is inclined about
45° downward to the left or the right.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Turning on the Appliance
Open the water supply.
Set the temperature regulator to opera-
tions with cold/ hot water.
Release the trigger gun. To do so, push
the safety catch towards the back.
Open the hand spray gun.
Start the motor with the trigger gun
open according to the operating instruc-
tions of the motor manufacturer.
Note: The spray lance or the nozzle can be
removed to facilitate the start-up process.
Note: If cleaning is not to be commenced
immediately, refer to interrupting operation.
Operating with cold water
Set thermostat to "Burner off" position.
Operating with hot water
DANGER
Scalding danger!
Set thermostat to desired working tem-
perature. The burner is switched on.
Operation with detergent
ATTENTION
Unsuitable detergents can cause damage
to the appliance and to the object to be
cleaned.
– For considerate treatment of the envi-
ronment use detergent economically.
– Observe the dosage and other instruc-
tions provided with these detergents.
– Use only those detergents approved by
the manufacturer of the appliance.
– Kärcher detergents ensure smooth
functioning. Please consult us or ask for
our catalogue or our detergent informa-
tion sheets.
Suspend end of suction hose in a con-
tainer filled with detergent.
Set nozzle to "CHEM".
Set dosing value for detergent to the
desired concentration.
Recommended cleaning method
– Loosen the dirt:
Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
– Remove the dirt:
Spray off loosened dirt with the high
pressure jet.
After operation with detergent
Set dosing value for detergent to "0".
Open the hand spray gun and rinse the
appliance for at least 1 minute.
– 6
EN
21
Tabla de contenido
