EdilKamin SIDE 50X50 Instalación Uso Y Mantenimiento página 20

IMPORTANT ADVICE REGARD-
ING THE INSTALLATION
Other than that described in this docu-
mentation, you are also asked to note the
following UNI standards:
Particularly:
- Before carrying out any assembly it is
important to verify compatibility of the
- When assembly is completed, the
installer must implement "start-up
operations" and issue documentation
paragraphs 4.6 and 5, respectively.
Before installing the lining, the correct
functioning of the connections, the
controls and all moving parts must be
checked.
a couple of hours, before covering the
need be.
such as:
- pilasters, painting, etc.
are carried out, once the tests are com-
pleted successfully.
ing from demolition as well as construc-
tion even if either occurs as a result,
after having replaced any damaged parts
All manuals and user guides at all-guides.com
INSTALLATION
Introduction
cording to the instructions given below,
system depend on correct installation.
tions carefully.
ty for any damages deriving from failure
to observe these instructions and in such
a case the guarantee shall not be valid.
assembled on disposable pallets.
Protection of the building
must be protected against over-heating.
The insulation measures to be adopted
depend on the type of surfaces and how
they are constructed.
Hot air vents / grills
from furniture.
the highest point of the lining, in order
to avoid the accumulation of hot air
within the lining itself.
that they are easily accessible for clean-
ing.
Ornamental beams
and at least 1 cm from the casing itself.
The cavity which insulates the orna-
mental elements and the casing must not
allow heat to accumulate.
Ornamental wooden beams must not be
integral parts of the building
-
- 20
-
-
Flooring in combustible materials must
must be:
-
at the front:
-
ment and in any case less than 50 cm
at the sides:
- more than 20 cm in respect of the
The structural elements constructed in
combustible material or which have
combustible elements and furniture
must be placed at least 80 cm from the
in front, above and at the sides.
If the said elements or pieces of furni-
ture are shielded by a ventilated anti-
irradiation protection, a distance of 40
The structural elements constructed in
combustible material or which have
combustible elements and furniture must
be placed at least 5 cm from the outer
In this space, environmental air must
circulate freely.
No accumulation of heat must be cre-
ated.
Electricity lines
There must be no electricity lines in the
tion area.
-
-
-