Cleaning Carpeted Stairs - Hoover fh50800 Manual Del Propietário

using the upholstery tool
2.16 Press power pedal to turn on. While depressing
solution spray trigger, push attachment forward.
Release trigger and pull attachment backward in
the same path to remove dirty water and solution
from upholstery. (For heavily soiled areas, repeat if
necessary.)
IMPORTANT
DO NOT oversaturate the upholstery.
FOR BEST CLEANING RESULTS USE
STEADY, MODERATE, FORWARD AND
BACKWARD MOTION. Make sure upholstery is
dry before use.
If the hose attachment door is not closed
completely, there will be no suction through the
nozzle and the unit will not operate properly.
CAUTION
!
Not to be used for grooming a pet.

CleaninG Carpeted stairs

Read "Before You Begin Cleaning" instructions on
page 6.
Place handle in upright position. Brushroll will not
rotate while handle is in upright position.
Fill clean water tank according to instructions.Fill
detergent container with HOOVER
detergent.
Do not point tools toward people or pets.
WARNING
!
Use extra care when cleaning on stairs. To avoid
personal injury or damage, and to prevent the
cleaner from falling, always place cleaner at
bottom of stairs or on floor. Do not place cleaner
on stairs or furniture, as it may result in injury or
damage.
Dry hands and plug cleaner into a properly grounded
outlet.
Turn cleaner ON.
2.18 Pre-spray the carpeted stair by holding the tool
about one inch above the carpet and push it forward
while pressing the trigger (equals one wet stroke).
Position tool against the riser and slightly press it
into carpet pile. Press the trigger and pull the tool
slowly over the carpet (second wet stroke). Release
trigger at end of stroke.
2.19 Lift tool, and position it against riser. Pull tool
slowly over carpet without pressing trigger (dry
stroke).
All manuals and user guides at all-guides.com
2.16
storinG tools
2.17 Place hose (A)
and upholstery attach-
ment
storage locations.
Store for next use.
!
2.18
® Deep Cleansing
Overlap strokes by 1/2 inch to help prevent
!
streaking.
It is best to alternate wet and dry strokes as
described above. End with more dry strokes to aid
in faster drying of carpet.
To avoid saturating carpet, do not use more than
4 wet strokes over any one area. Always end with
dry strokes.
If additional cleaning is necessary, wait until the
carpet is completely dry before using the tool again.
Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction.
When finished cleaning, empty Clean Water Tank,
wash and rinse dirty Water Tank and let air dry.
9
2.17
(B) into their
A
2.19
b