I Starting The Cleaning Cycle - Polaris W Serie Manual De Instalacion Y Uso

2.4 I Starting the cleaning cycle

To prevent all risks of injury or equipment damage, comply with the following directives:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during shock chlorination.
• Do not leave the appliance unattended for an extended period.
• Do not use the appliance if the roller shutter is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The action in progress
- The cleaning cycle selected (depending on the model)
- that maintenance is required
• The control box switches to standby after 10 minutes and the screen is switched off. Press any key to exit standby
mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.4.1 Selecting the cleaning cycle (depending on the model)
• A cleaning cycle is already configured by default: the symbols are lit.
• The cleaning cycle can be selected at any time, before the appliance starts or while it is operating. The new cycle will
start immediately.
• The cleaner adapts its movement strategy depending on the choice in order to optimise coverage.
2.4.2 Launching the cleaning cycle
• Press
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in floor only mode (after removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the filter less clogged.
2.4.3 Adjusting the cleaning time (depending on model)
• You may reduce or increase the cleaning time at any time (+/- 0.5 H).
• Press the button:
11
Surface to be cleaned
Floor only
Floor + walls + waterline
- 0.5 H
Normal
Durée
+ 0.5 H
normale
duration