Polaris W Serie Manual De Instalacion Y Uso página 13

2.4.4 Surface control
• Check that the cleaner filter is clean so as not to affect the cleaner's behaviour.
• Once the cleaning cycle has been launched, monitor the cleaner's behaviour when climbing the walls and when it
brushes the waterline.
(Surface Control System) button at any time depending on the cleaner's behaviour: refer to the
• You can use the
table below.
• The new configuration will be effective the next time the cleaner climbs the walls.
• 2 LEDs are lit by default
Cleaner behaviour to be observed
The cleaner quickly climbs the walls and goes past the
waterline, aspirating air: Reduce the number of LEDs.
The cleaner slowly climbs the walls and stops below the
waterline: Increase the number of LEDs.
Tip: Optimise wall cleaning and water line brushing operations
According to the type of pool lining, the cleaner will behave differently when climbing the walls. The cleaner
has the function to optimise wall cleaning, then waterline brushing on all types of lining.
However the
is moving across the floor of the pool.
.
function is set, the suction power remains at its maximum at all times when the cleaner
Action
Press:
EN
12