I Replacing The Brushes - Polaris W Serie Manual De Instalacion Y Uso

3.5 I Replacing the brushes

3.5.1 PVA brushes: Polyester, tiled, enamel pools (depending on the model)
• The PVA brushes must be replaced by the retailer.
3.5.2 Flap brushes (depending on the model)
• Each brush is equipped with wear indicators; the distance between the indicators and the end of the brush indicates
whether the brush is in good condition (see figure
• The brushes are worn and should be replaced when the wear indicators appear as shown in figure
• To remove worn brushes, remove the tabs from the holes in which they are fixed (see figure
• To fit new brushes, start by fitting the side without tabs under the brush holder (see figure
• Roll the brush around its support, slide the tabs into the attachment holes and pull on the end of each tab until its
edge passes through the slit (see figure
• Cut the tabs using a pair of scissors for them to be level with the other blades (see figure
17
).
).
.
).
).
).