Replacing The Timer Battery; Cleaning; Test; Storage - Steinbach Premium 100 Manual Original

12
14. Insert the elbow of the check valve.
9
15. Insert the screen .
8
16. Carry out the steps described in the "Preparing the filter vessel" section.
The filter medium is exchanged.

Replacing the timer battery

1. Make sure that the pump's power cable is disconnected from the power supply.
2. Undo the screws of the timer cover with a Phillips screwdriver PH1 and remove the cover.
3. Lightly push down on one edge of the battery to loosen it. Remove the battery.
4. Replace the battery (see section "Technical data").
5. Screw the cover back on.
The timer battery is exchanged.

Cleaning

Only clean the device with a standard bathroom cleaner, clear tap water and a lint-free cloth. Aggressive
cleaning agents can damage the device. Dry the product with a lint-free cloth.

Test

Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Are the accessories in flawless condition?
- Are all lines in flawless condition?
- Are the ventilation slots unobstructed and clean?
Do not start up a damaged device or damaged accessories. Have them checked by the manufacturer or
its customer service or a qualified service technician.

Storage

Winter storage

Store the filter system in a dry and frost-free place (>= +5 °C) away from direct sunlight.
Always store the dried filter medium separately from the filter vessel over the winter.
1. Switch the pump
14
2. Close the shut-off valves or block the water flow to the pool's connecting hoses.
3. Uninstall the connecting lines to the pool and drain the hoses.
4. Lift the pump and drain it via the two connections.
38
13
9
off by pulling the power plug.
8