Exclusion Of Liability; Information About The Product; Correct Purpose Of Use - hafele DT 100 Manual De Instrucciones

1.4 Exclusion
of liability

2. Information about the product

2.1 Correct purpose
of use
Service and maintenance personnel
Cleaning work on the product may be carried out by the operating personnel
(after obtaining authorisation from the operator).
The batteries must only be changed by trained experts that have been deployed
by the owner. Other maintenance work is not permitted.
These instructions describe the qualifications listed below for the personnel for
the various work areas:
Qualified electrician
Qualified electricians are capable of working on electrical systems and recognise
potential hazards and avoid them due to their professional training, knowledge,
experience as well as knowledge of pertinent standards and provisions.
Qualified electricians have been specifically trained for the working environment
in which they operate and know the relevant standards and regulations.
Unauthorised persons
WARNING
Danger to life for unauthorised persons due to hazards in the danger
zone and working area!
Unauthorised persons who do not meet the requirements described herein
will not be aware of the occupational hazards. Therefore, unauthorised
persons are subject to risks of serious injury or death.
• Keep unauthorised persons away from the danger zone and working
area.
• When in doubt, approach persons and have them clear the danger
zone and working area.
• Interrupt the work until unauthorised persons have left the danger zone
and working area.
No liability is accepted for injuries or damage that is attributable to one or more of
the following reasons:
• Failure to read and/or follow the instructions
• abuse of the equipment
• omission of the emergency opening facility
• inadequately qualified / instructed personnel
• failure to use original replacement parts
• negligent handling of the product
The product is an electronic door fitting for use in hotels, hospitals and other
buildings with frequent changes of room occupant.
The operator must equip the relevant doors with a single profile cylinder for
emergency opening in the event of faults or emergencies.
The product is intended for the following areas of application:
• Use on room doors inside buildings
• Use on doors that comply with the specified installation requirements
(see chapter "3. Installation requirements" of the installation instructions)
Correct purpose of use also includes adhering to the manufacturer's operating,
service and maintenance conditions.
en
19