Lionelo Bastiaan One Manual De Usuario página 16

safety seat (marked as 15 in fig. 3) and then under seat liner (fig. 18).
e.
Fasten the belts. Press the child safety seat against the car seat.
Tighten the belt as showed by arrows in the figure 18.
f.
Move the child safety seat to check if it has been securely fixed. If
the product fixing is unstable, adjust the belt tension.
g.
Put the child in the child safety seat and fasten its safety belts.
2. Rear-facing position with ISOFIX and TOP TETHER
(groups 0+, I)
a.
Rotate the seat by 90 degrees. Grab the inclination adjustment lever
and incline the seat as far as possible (fifth level - „half-lying"). Rotate
the seat again so that it is in a rear-facing position.
b.
If necessary, put ISOFIX covers on ISOFIX connectors in the car.
They help you stick ISOFIX fasteners when the car connectors are
hard to access.
c.
Position the child safety seat on the car seat in a rear-facing position.
d.
Press ISOFIX button to pull out both ISOFIX arms. Grab the child
safety seat and slide two ISOFIX arms into fasteners located in the car
seat until they engage and you can hear a distinctive „click" (fig. 19).
e.
Push the child safety seat against the car seat as far as you can. The
marker on both sides of ISOFIX arms should turn from red into green.
f.
Pull out TOP TETHER fixing belt and unroll it with the use of
adjustment device (fig. 20).
g.
Fasten TOP TETHER belt in the spot recommended in the vehicle
manual. The upper belt fastening spot may differ, depending on the
car model (fig. 21). Tighten TOP TETHER fixing belt so that a green
marker shows up on the buckle.
h.
Put the child in the child safety seat and secure with its safety belts.
3. Forward-facing position with seat belts or seat belts
and ISOFIX connectors (group I)
ISOFIX (optional)
a.
If necessary, put ISOFIX covers on ISOFIX connectors in the car.
EN ‑ 16 ‑