•
Do not cut in the danger area.
•
Do not force the trimmer head into uncut grass.
•
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood
can wear the cutting line quickly.
DANGER
AREA
9.8
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (1) on
the guard. The line cut off blade continuously trims the
line to ensure a consistent and efficient cut diameter.
Advance line whenever you hear the motor running
faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep line long enough to advance properly.
9.9
CHANGE TO THE EDGING MODE
NOTE
You can change the machine to a well groomed edger
for edging patios, driveways and walkways or other
areas.
1. Stop the machine.
2. Loosen the screws.
3. Push on the rotating handle latches and turn the
trimmer head 180 degrees until the trimmer head
locks into position.
1
4. Release rotating handle latches (1).
5. Insert the screws into the shaft.
6. Tighten the screws.
English
DIRECTION OF
ROTATION
BEST CUTTING AREA
10
MAINTENANCE
IMPORTANT
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
IMPORTANT
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
IMPORTANT
Use only the replacement parts and accessories of the
initial manufacturer.
10.1 GENERAL INFORMATION
IMPORTANT
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety
glasses.
10.2 CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3 REPLACE THE SPOOL
1. Push the tabs on the sides of the trimmer head at
the same time.
9
EN