Replace The Cutting Line - Powerworks XB 20V Manual Del Operador

EN
2. Pull and remove the spool cover.
Cover
Spool
3. Remove the spool.
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5. Put the end of the cutting line through the eyelet.
6. Extend the cutting line to release it from the guide
slot in the spool.
Line exit hole
7. Push the tabs and install the spool cover onto the
spool housing.
NOTE
English
8. Push the spool cover until it clicks into position.

10.4 REPLACE THE CUTTING LINE

Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of .065" (1.65 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot.
10
NOTE
NOTE