Tabla de contenido
On/Off Button (see A)
LCD Display Window (see B)
Tank Pressure Button (see C)
Tank Pressure Indicator (see D) This indicator will assume a red color when the tank is pressurized.
WARNING:
Risk of injury. Before transporting or performing any type of service to the unit, always shut off the compressor,
remove the plug from the outlet and bleed all the pressure from the system through the outlet hose or by pulling the relief valve
ring and opening the petcock on the bottom of the tank (see the "Maintence" section of this manual for instructions).
Pressure Relief Valve (see E)
Air Pressure Regulator Knob
(see F)
WARNING:
Never Exceed the maximum working pressure of the tool. Turn the knob clockwise to increase pressure and
counterclockwise to decrease pressure.
Air Line Outlet (see G)
8
COMPRESSOR CONTROLS
DIGITAL CONTROL PANEL
When the unit is plugged in, this button turns the compressor on. It is operated
manually, but when in the ON position, it allows the compressor to start up or shut
down automatically, without warning, upon air demand. The on/off icon will be shown
on the display. ALWAYS turn the unit OFF when the compressor is not being used,
and before unplugging the compressor.
This display will automatically show the regulated outlet pressure when the
unit is on. The on/off icon and the tool icon will be shown on the display.
The display will automatically show the tank pressure when the unit is off but still plugged in, if
the pressure is not zero.
Pressing this button will show the pressure level of the air stored in the tank and the
tank icon will be shown in the display. It is not adjustable by the operator and does
not indicate line pressure.
Releasing this button will return the display to regulated pressure and the
on/off icon and the tool icon will be shown in the display. It is not adjustable
by the operator and does not indicate line pressure.
When there is zero tank pressure the indicator will not be visible.
If the control board does not shut down the motor when the pressure reaches the preset level,
this valve will pop open automatically to prevent over pressurization. To operate manually, pull
the ring on the valve to relieve air pressure in the tank.
The air pressure regulator knob enables you to adjust line pressure to the tool you are using.
Turn the regulator knob clockwise to increase the regulated pressure and counter clockwise to
decrease the regulated pressure (see H).
Connect a ¼" female connector and an air hose to this outlet (not included with some
compressors) (see I).
H
I
200-2558
Tabla de contenido
