Connecting A Mobile Device; Settings - Festool CTLC SYS I Manual De Instrucciones Original

The cordless mobile dust extractor can be
connected to as many as five remote con­
trols at the same time. The cordless mo­
bile dust extractor can only be connected
to one battery-powered power tool at a
time.
If a cordless mobile dust extractor which
was initially switched on using the battery
pack is switched off using the remote con­
trol, the temporary connection between
the connected battery pack and the cord­
less mobile dust extractor will be lost. The
battery pack can then be connected again.
► Hold down the connection button [1-9] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-10] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Press the MAN button [1-18] on the remote
control.
The remote control is permanently stored in the
cordless mobile dust extractor.
Resetting on the remote control
Resetting deletes the connection between a re­
mote control and the cordless mobile dust ex­
tractor.
► Press and hold the connection button [1-16]
and the MAN button [1-18] for 10 seconds.
The LED indicator [1-17] lights up purple, if the
reset has taken place.
9.3

Connecting a mobile device

The cordless mobile dust extractor can be con­
nected to a mobile device (e.g. for a software
update) using the Festool Work app.
► Hold down the connection button [1-9] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-10] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Follow the instructions provided in the
Festool Work app to authorise the secure
connection.

10 Settings

10.1 Adjusting the suction power
► Press the plus or minus button for the suc­
tion power adjustment [1-11] while extract­
ing.
The green LEDs on the status display [1-12] in­
dicate the current performance level.
10.2 Connecting sleeve
The bypass function of the connecting
sleeve [1-3] prevents strong suction from
sanding machines and floor nozzles on smooth
surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi­
tion.
Close
► Turn the adjusting ring to the "CLOSE" posi­
tion.
10.3 Volumetric flow monitoring (only for
dust class M)
CAUTION
Hazardous dust
Damage to the respiratory passage
► Correct functioning of volumetric flow
monitoring is only ensured with the suction
hose D 27x3m-AS-90°/CT.
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s.
Possible causes
Filter bag full.
Dirty main filter.
Suction hose is
blocked or kinked.
Value set on the
suction power ad­
justment [1-11] is
too low.
Battery charge level
low.
Electronic monitor­
ing malfunction.
Working with sand­
ers.
English
Solution
Insert a new filter bag
(see section 14.1).
Change the main filter
(see section 14.2).
Eliminate the block or
straighten the hose.
Set the suction power
to a higher value (see
section 10.1).
- Charge battery
packs.
- Use new battery
packs.
Have the fault rectified
by a Festool service
workshop.
Activate the bypass
function (see sec­
tion 10.2).
23