Creating A Personal Database - Waeco ASC 6100G Instrucciones De Uso

English
11. Enter the user name and press ENTER to confirm:
ADM AREA
User number
User name
John Citizen
ADM AREA
User number
John Citizen
The user is created and the menu changes again to the user selection.
12. Proceed as follows:
• Create another user by using the cursor keys to select Database and proceed as described.
• To exit the menu press STOP.
13.3.2 Entering user codes
If a user code has been created, the same code must be used to enable the A/C service unit.
Enter the user code.
ENTER USER CODE
If you enter an incorrect user code, the following error message appears:
WRONG CODE
Once the correct code is entered, the A/C service unit is enabled and starts up. The user's name is dis-
played:
John Citizen
13.4

Creating a personal database

You can enter up to 100 customer-specific vehicles with the corresponding filling quantities in this database. The
personal entries are saved in the control board, not on the flash memory card. The entries will be retained even
after updating the software. The entries are stored chronologically, not alphanumerically.
1.
In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER to confirm.
3. Enter the vehicle license plate number (this can also be left blank) and press ENTER to confirm.
CAR DATA
PLATE NR:
16
1
1
----
or to select Short selection.