Troubleshooting - UFESA PV3600 almeria Manual De Instrucciones

DESCALING PROCESS
1. Fill half of the water tank.
2. Set the temperature control (7) to the "max" position and plug in the iron.
3. After the necessary warm-up period, the pilot light (9) goes out. Then, unplug the iron (very
important!).
4. Hold the iron horizontally over a sink. Keep the setting
5. Shake the iron back and forth. Boiling water and steam will come out, carrying scale or deposits that
might be there.
6. When the tank is empty, release the steam regulator and set it to position "0". Reconnect the iron to
evaporate the remaining water.
7. Unplug the iron and move it over a preferably old piece of cloth. This ensures that the soleplate is dry
when storing the appliance.
It is recommended to carry out the self-cleaning at least every two weeks.
TROUBLE SHOOTING
Problem
The iron does not heat up
Steam does not come out
Shot of steam / vertical ironing
function does not work
22
Probable cause
Connection problem
Temperature control (7) set to a low
position
The auto shut-o system has been
activated (indicator light 11* flashes)
Not enough water in the tank
Steam regulator (3) is set to "0"
position
Selected temperature is lower than
that specified to use with steam
Iron is not hot enough
Selected temperature is lower than
that specified to use with steam
selected with the steam regulator (3).
Solution
Check main power supply cable
plug and outlet
Turn to a higher position, if
compatible with the fabric
To reconnect the iron, just move it
about gently
Fill the water tank
Set the steam regulator to a higher
position
Set to a higher temperature, if
compatible with the fabric
Set a suitable temperature and wait
until the pilot light (9) goes out
Set a higher temperature, if
compatible with the fabric