Troubleshooting - UFESA Planet Serie Instrucciones De Uso

Important:
• Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
STORING THE APPLIANCE (D)
iron
ched
1. Always allow the appliance to cool down before
storing it.
ning
have
then
TROUBLE SHOOTING
e on
n not
Problem
The steam generator
does not come on.
water
The iron does not
eam
heat up.
g the
The iron begins to
11)
smoke when switched
on.
long
Water flows through
the holes on the sole
ease
plate.
max»
Dirt comes out
through the sole plate.
ents
tical
11).
The iron does not
the
produce any steam.
th a
an it
The ironed garment
turns dark and/or
sticks to the soleplate.
Possible causes
• There is a connection
• The main power button is not switched
on.
• The main power button is not switched
on.
• The temperature control knob is set to
the «min» position.
• During first use: Certain components on
the appliance have been lightly greased
at the factory and may produce a little
smoke when initially heated.
• During later use: the soleplate may be
soiled.
• The steam function is being used before
it has reached temperature.
• The water is condensing inside the pipes
because steam is being used for the first
time or has not been used for a long
time.
• There is a build-up
or minerals in the
• Chemical products or additives have
been used.
• The boiler is not switched on or the
water tank is empty.
• The water tank is not fitted onto the
housing correctly.
• The steam regulator is set to the minimum
position.
• The selected temperature is too high and
has damaged the garment.
2. Set the main power to the «0» position and
disconnect the mains cable.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the water tank and store the mains cable on
the cord rewind facility. Tidy the steam hose on the
handle of the iron using the cord clip provided (14).
Do not wrap the cords too tight.
problem. • Check the mains cable, the plug and the
socket.
• Set the main power (6) button to the «I»
position.
• Set the main power (6) button to the «I»
position.
• Set the temperature control knob (10) to
the desired position.
• This is
will stop
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing at
low temperatures (Variable steam control
(4)).
• Point the iron away from the ironing area
and press the steam release button (11)
until steam is produced.
of scale • Use tap water mixed 50% with distilled
steam tank. or demineralised water. If the tap water
in your district is very hard, mix tap water
with distilled water 1:2.
• Clean the sole plate with a damp cloth.
• Never add products to the boiler water.
• Set the main power (6) button to the «I»
position and/or fill the water tank.
• Fit the water tank back onto the housing
correctly (you will hear a click).
• Increase the steam flow by turning the
steam control (4).
• Select a suitable temperature for the
material being and clean the sole plate
with a damp cloth.
Solution
completely normal and
after a short while.