Turning Off The Device - Geutebruck G-ST 3000+ G2 Manual De Instalación

G-ST 3000+G2

Turning off the device

V 1.0
 Audio
An audio source can be connected at the soundcard ports.
Figure 12: Audio connections
COM1

At the COM1 port, there is a RS-232 interface via a 9-pin Sub-D socket.
The 9-pin COM1 plugs are assigned by default as follows:
Figure 12: Pin assignment for COM1 connection – solder-side socket
Pin Function
1 JDCD
2 RxD
3 TxD
To turn off your G-ST, proceed in the following order:
1. Close all applications and click Start in the taskbar.
2. Select Shut down and press OK.
The operating system will now shut down and all data will be stored.
3. Next, turn your device off completely with the on/off switch on the rear of the
device.
Pin Function
4 DTR
5 Signal ground (GND)
6 DSR
Back to the
table of contents
Line in
Line out
Pin Function
7 RTS
8 CTS
9 RI
19