Geutebruck G-ST 3000+ G2 Manual De Instalación página 38

G-ST 3000+G2
Integrating the device into the network
V 1.0
2. Select a language and click "Next". The corresponding language pack is in-
stalled.
3. Open the Region and Language options, by right clicking Start, Control Panel
and then Language.
4. Click Add a Language to access the selection menu. Select your language and
click "Add".
5. By clicking on your country language and on Options you access the activation
menu for the primary language.
6. Activate your language by clicking "Make this the primary language" and follow
the instructions.
It is best to have the following work performed by an administrator:
1. Assign the G-ST the intended IP address in order to integrate it into the network.
Manual assignment of IP addresses is performed using the settings of the net-
work card of the device.
2. Using the console command PING, check whether the device was integrated
correctly into the network. You start the command window using right klick on
Start  left klick on Command prompt  enter PING + IP adress.
In general, when assigning an IP address, make sure that the assigned address is in
fact available and not already assigned to another network component.
Back to the
table of contents
13