Preparations; Instructions On Installation Of In-House Pc Cards And External Devices - Geutebruck G-ST 3000+ G2 Manual De Instalación

G-ST 3000+G2

Preparations

Before you begin establishing connections and specifying configurations, you should
familiarize yourself with the hardware and use of your system:





You should also be experienced in dealing with MS Windows and be able to in-
stall hardware and software.
For setup of network applications, you should also have the following information
Network
available to you:
applications



Instructions on installation of in-house PC cards and external devices

To avoid expensive installation and to ensure correct operation, consider the following:



For connecting external devices, note in general:



10
Number and manufacturer of the recording cameras.
Number and type of input contacts for event recording.
For serial connection of cash-dispensing machines or access control systems
with card readers, the protocol used and the serial parameters.
The required storage capacity for image data (take into account an additional
15% of the calculated image storage capacity for management of images).
Recording grid (number of images per unit time) of the corresponding cameras
for permanent and/or event recording.
Network topology and technology and responsibilities of your system.
Computer name and/or IP addresses of the computers and devices to be set.
Wherever possible, use PC cards offered by GEUTEBRÜCK. If you ordered
these cards with the device, they are already installed and ready for operation.
When re-ordering a card, we strongly recommend also ordering assembly and
the installation at the same time.
Installation of third-party PC cards is performed at your own risk as we cannot
ensure proper system function in such a case.
Use only monitors that meet the minimum requirements set out here. If possible,
use only standard PC keyboards and mice that are MS Windows-compatible.
If possible, use printers that are supported by MS Windows and whose printer
drivers can be found on the system disk in the Windows directory.
G-ST 3000+ G2 devices do not have a CD-ROM/DVD drive.
For the use of a recovery DVD you need an external USB drive. When selecting
devices, please ensure that the devices are compatible with MS Windows.
In this context, please also take into account the training that GEUTEBRÜCK of-
fers for safe use of the hardware and software of the G-ST.
Back to the
table of contents
V 1.0