Tripp-Lite SRXCOOL12KEU Manual Del Propietário página 7

Installation
Drop Ceiling Exhaust Connection
4
Warning: Some ceilings may require modified installation procedures. The user
must determine the fitness of hardware and procedures before installing. The
procedures described in this manual may not be appropriate for all applications.
4-1 Choose a removable drop ceiling panel near the unit to provide the straightest, shortest
path available for the flexible exhaust duct. Measure the width of the ceiling panel,
including the portion that rests on the ceiling grid. Combine the two sections of the
adjustable exhaust panel, then adjust the exhaust panel to match the width of the ceiling
panel. After the exhaust panel is set to the correct width, use the included self-tapping
screw to lock it in place.
Note: The exhaust panel can adjust from 20.5 to 49.2 inches (52.1 to 104.1 cm).
Certain installations may require trimming the exhaust panel for a proper fit.
Insert the exhaust duct adapter into the oblong hole in the adjustable exhaust panel. The
4-2
adapter will snap into place.
4-3 Slide the ceiling panel out of the way and place the exhaust panel inside the ceiling space.
Allow the exhaust panel to rest on top of the ceiling grid.
Note: There must be at least 10 inches (25.4 cm) of open space above the exhaust panel
to allow adequate airflow.
Slide the ceiling panel back into place so that it adjoins the exhaust panel and closes any
4-4
gaps in the ceiling. A tight seal will permit maximum cooling efficiency. If the installation is
permanent, trim the ceiling panel so it doesn't overlap the ceiling grid.
Note: The flexible exhaust duct can extend to a maximum length of 118 inches (300 cm).
Provide the straightest, shortest path available. Excessive bending or stretching of the duct
will reduce cooling efficiency.
After completing step , proceed to step
4
Window Exhaust Connection
5
Warning: Some windows may require modified installation procedures. The user
must determine the fitness of hardware and procedures before installing. The
procedures described in this manual may not be appropriate for all applications.
5-1
Measure the window opening. Combine the two sections of the adjustable exhaust panel,
then adjust the exhaust panel to match the width of the window opening. After the exhaust
panel is set to the correct width, use the included self-tapping screw to lock it in place.
Note: The exhaust panel can adjust from 20.5 to 49.2 inches (52.1 to 104.1 cm). It is
compatible with vertical and horizontal mounting.
5-2
Insert the exhaust duct adapter into the oblong hole in the adjustable exhaust panel. The
adapter will snap into place.
.
6
7
Self-Tapping Screw
4-1
Horizontal Window
Opening
4-2
Ceiling Panel
(From Below)
4-3
Ceiling Panel
(From Above)
Exhaust Panel
4-4
Self-Tapping Screw
5-1
Horizontal Window
Opening
5-2
Vertical
Window
Opening
Vertical
Window
Opening